 Replacing spark plugs causes engine to stall at idle? |
| Replacing spark plugs causes engine to stall at idle? |
 May 26 2009, 06:49 AM
Post
#1
|
|
 Group: Admin Posts: 3,402 Joined: 23-February 06 From: PDX/TXL Member No.: 35  |
I had the spark plugs and wires replaced in my Honda Accord recently and was driving it this morning and had it stall out at idle while sitting at a light. It seemed like it was fine but then at 70mph it would lose RPM and then immediately jump back up. I thought it may be a computer being reset issue, but wouldn't that correct itself after a few miles?
-------------------- "There is a level of cowardice lower than that of the conformist: that of the fashionable non-conformist." |
 |
 
|
 |
|
May 28 2009, 10:01 AM
Post
#2
|
|
|
Group: Admin Posts: 3,402 Joined: 23-February 06 From: PDX/TXL Member No.: 35 |
Thanks for all of the suggestions!
I drove it into work again today and had a long period of the tach going to zero. The car essentially stalled while going 70mph, stayed like that for around 5-7 seconds, then the tach jumped back up to normal RPM. I'm taking it in today. -------------------- "There is a level of cowardice lower than that of the conformist: that of the fashionable non-conformist." |
|
|
|
Hartmann Replacing spark plugs causes engine to stall at idle? May 26 2009, 06:49 AM
Mommy Had a similar issue and it was caused by a hose is... May 26 2009, 08:11 AM chook wires could have bad connection. Happened on my m... May 26 2009, 09:56 AM
Hartmann QUOTE (chook @ May 26 2009, 10:56 AM) wir... May 26 2009, 10:07 AM impala454 check the O2 sensor connection May 26 2009, 11:01 AM Dogmeat Did you use dilectric grease in the plug boots? Di... May 26 2009, 08:05 PM chook If it stalls only after heating up, it could be ga... May 26 2009, 10:47 PM woody crossed wires?
example: plug 1 & plug 2 wires... May 27 2009, 02:33 PM impala454 definitely not crossed wires. try that on your ow... May 27 2009, 03:36 PM impala454 my bet is still on the O2 sensor May 28 2009, 10:04 AM Hartmann It ended up being the distributor (not the cap). T... May 29 2009, 09:43 AM |
| Lo-Fi Version | Time is now: 7th December 2025 - 05:35 PM |
