IPB

Welcome Guest ( Log In | Register )


> Replacing spark plugs causes engine to stall at idle?
Hartmann
post May 26 2009, 06:49 AM
Post #1





Group: Admin
Posts: 3,403
Joined: 23-February 06
From: PDX/TXL
Member No.: 35



I had the spark plugs and wires replaced in my Honda Accord recently and was driving it this morning and had it stall out at idle while sitting at a light. It seemed like it was fine but then at 70mph it would lose RPM and then immediately jump back up. I thought it may be a computer being reset issue, but wouldn't that correct itself after a few miles?


--------------------

"There is a level of cowardice lower than that of the conformist: that of the fashionable non-conformist."
Go to the top of the page
 
+Quote Post
 
Start new topic
Replies
Dogmeat
post May 26 2009, 08:05 PM
Post #2


DEATH TO ....something?


Group: Members
Posts: 5,618
Joined: 23-February 06
From: Parker, CO
Member No.: 55



Did you use dilectric grease in the plug boots? Did you replace the wires and use dilectric grease all around? It could be a wire shorting or arcing on you.

Also, general rule of thumb when changing spark plugs: Put the same brand back in that came out.

IE, don't waste your money on a bullshit set of Bosch +4 or +2 plugs. If it came with Champion plugs, put Champion plugs back in. If it came with Delco platinum plugs, put Delco platinum plugs back in.

just seems to work better that way.


--------------------
I r Ur Gawd!
Go to the top of the page
 
+Quote Post

Posts in this topic


Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:

 



Lo-Fi Version Time is now: 22nd September 2026 - 06:45 AM
Skin made by: skeedio.com